Server maintenance is scheduled for Saturday, December 21st between 6am-10am CST.

During that time, parts of our website will be affected until maintenance is completed. Thank you for your patience.

Menu
Search
Filters
Close
Menu

51315-5819-Corrosion Inhibition in Oil/Water Environments

Picture for Corrosion Inhibition in Oil/Water Environments
Available for download
Product Number: 51315-5819-SG
ISBN: 5819 2015 CP
Author: Michael W. Keller
Publication Date: 2015
$0.00
$0.00
$0.00
The use of corrosion inhibitors in multiphase flow environments consisting of oil/water mixtures is common in a variety of industries. Frequently oil is assumed to reduce uninhibited corrosion rate which could lead to lower required concentrations of inhibitor to maintain protection. In this paper we present the results of a study of inhibited corrosion in multiphase flow. These results are obtained from a novel three-cell flow loop (EC3) that is capable of simultaneous independent measurement of corrosion erosion and erosion-corrosion. The efficiency of inhibitor in oil-water flow is measured at three water-cuts 100% 40% and 20%. Increasing oil content was found to lower the baseline 0 ppm inhibitor corrosion rate when decreasing water cut from 100% to 40%. Further decreasing water-cut did not have a statistically significant effect. Increasing oil content was found to reduce inhibitor surface coverage likely due to a combination of adsorption of inhibitor to oil-water interfaces and dissolution of inhibitor in the oil phase.
The use of corrosion inhibitors in multiphase flow environments consisting of oil/water mixtures is common in a variety of industries. Frequently oil is assumed to reduce uninhibited corrosion rate which could lead to lower required concentrations of inhibitor to maintain protection. In this paper we present the results of a study of inhibited corrosion in multiphase flow. These results are obtained from a novel three-cell flow loop (EC3) that is capable of simultaneous independent measurement of corrosion erosion and erosion-corrosion. The efficiency of inhibitor in oil-water flow is measured at three water-cuts 100% 40% and 20%. Increasing oil content was found to lower the baseline 0 ppm inhibitor corrosion rate when decreasing water cut from 100% to 40%. Further decreasing water-cut did not have a statistically significant effect. Increasing oil content was found to reduce inhibitor surface coverage likely due to a combination of adsorption of inhibitor to oil-water interfaces and dissolution of inhibitor in the oil phase.
Product tags
Also Purchased
Picture for Corrosion and Galvanic Behavior of Oil and Gas Materials in TM0177 Test Solution A
Available for download

51315-5818-Corrosion and Galvanic Behavior of Oil and Gas Materials in TM0177 Test Solution A

Product Number: 51315-5818-SG
ISBN: 5818 2015 CP
Author: Raul Rebak
Publication Date: 2015
$0.00
Picture for Corrosivity and Corrosion Inhibition of Wet-Sour Crude Oil Wells
Available for download

51315-5759-Corrosivity and Corrosion Inhibition of Wet-Sour Crude Oil Wells

Product Number: 51315-5759-SG
ISBN: 5759 2015 CP
Author: Yahya Al-Janabi
Publication Date: 2015
$0.00
Picture for CP Management of Multiple Pipeline Right-of-Ways
Available for download

51315-5795-CP Management of Multiple Pipeline Right-of-Ways

Product Number: 51315-5795-SG
ISBN: 5795 2015 CP
Author: Len Krissa
Publication Date: 2015
$0.00
Categories
Industry
Recently viewed
Popular tags
View all

Association for Materials Protection and Performance

© AMPP All Rights Reserved.
Membership Terms of Content Use
Contact Customer Support